DCA-600SSV Manual - Multiquip Inc.

DCA-600SSV— GENERATOR START-UP PROCEDURE (MANUAL)16. The ammeter (Figure 54) will indicate zero amps with noload applied. When a load is applied, the ammeter willindicate the amount of current that the load is drawingfrom the generator.20. Press the main circuit breaker “ON” switch (Figure 58).Figure 58. Main Circuit Breaker ON SwitchFigure 54. Ammeter (No Load)17. The engine oil pressure gauge (Figure 55) will indicatethe oil pressure (kg/ cm 2 ) of the engine. Under normaloperating conditions the oil pressure is approximately21. Verify that the main circuit breaker “ON” lamp (Figure 59)is lit (ON).0ENGINE OIL PRESSUREkg/cm248Figure 55. Oil Pressure Gauge18. The coolant temperature gauge (Figure 56) will indicatethe coolant temperature. Under normal operatingconditions the coolant temperature should be between167 and 203 degrees Fahrenheit (Green Zone).Figure 59. Main Circuit Breaker ON Lamp22. Place the G.F.C.I. and aux. circuit breakers (Figure 60) in the“OFF” position prior to starting the engine.WATER TEMPFigure 56. Coolant Temperature Gauge19. The tachometer gauge (Figure 57) will indicate thespeed of the engine when the generator is operating.Under normal operating conditions this speed isapproximately 1800 RPM’s.Figure 60. GFCI and AuxiliaryCircuit Breakers (ON)Figure 57. Engine Tachometer GaugeDCA-600SSV — OPERATION AND PARTS MANUAL — REV. #0 (07/13/09) — PAGE 41