ASSEMBLY MANUAL - Hobie Cat

MAST SET UPTrapeze wiresTrapeze wires1Place the mast onto two supports or padding.Unroll the trapeze wires and fix them using the 6 mmbow shackle to the upper hole on the mast tang (twoon each side).ForestayShroudsUnroll the shrouds and the forestay wire (with2the jib halyard block) and fix them to the lowerhole of the mast tang using the 8 mm bow shackle.The shrouds go onto each side of the forestay.IMPORTANT : Do not forget to attach the jib halyardrope to the small single block at the end of3the jib halyard wire. Tie off the jib halyard wireand rope near the base of the mast.NB: If you have chosen the optional spinnaker kit, fitthe spinnaker halyard now, passing it behind the halyardyoke and around the pulley. Both ends then goover the shrouds and trapeze wires. One end of thehalyard passes between the spreader arm and braceon the starboard side of the mast. Secure both endsnear the base of the mast.9