Ixia Black Book: 802.11ac Wi-Fi Benchmarking

Test Case: Throughput Benchmark Test3. Connect to test chassis and select port to use for following test.Figure 26.Port ReservationClick the Test setup button to configure the test. The defaults on this page are used toperform the throughput tests. Make sure the loss tolerance is set for 0.1%.Note: The loss tolerance allows the throughput trial to pass if there is a small amount ofloss. This loss will commonly occur with the first few frames in a trial. If this value is set tozero loss tolerance, which is the definition in RFC-2544, it is not un-common for APs tohave a throughput of 0 for all the frames.PN 915-2634-01 Rev A December 2012 41