Machine Manual - Production Tool Supply

PREVENTIVE MAINTENANCE LUBRICATION CHART MODEL F-16-1 BUILD .003The following recommendations are for nominal clean operations.Consider shop conditions and machine use when wiping oil on exposed areas.Saw blade and guide lubrication depends on a properly functioning coolant distributionsystem. Check the coolant pump screens often to be sure they are clean and in place.Clean the coolant pan and change or filter the coolant fluid often, depending on coolanttype and machine use.NOTE: 80 Hour, one-time maintenance:See maintenance section IV c, page 11, for the first gear case oil change.200 HOURS 2,000 HOURSGREASE with Mobilith AW 2Blade tension wheel slide,under the wheel.Saw head post at grease fitting.Blade tension screw.CRC 336 or equalCLEAN FIRST, THEN APPLYCylinder rods.Saw head posts.Guide arm beam.Door hinges and latches.Vise screw. Add a few drops to thebearing on the end of the screw.Vise slides.OTHER 2,000 HOUR MAINTENANCESee the OEM bulletins on the contents page.Drive gear reducers, Mobil SHC 634 synthetic.10,000 HOURSVariable speed pulleys. See theSee maintenance section.Hydraulic reservoir.Change requires 3/4 gallons ofMobil DTE 24.Tension wheel bearings.Remove axle nut, front bearing andall old grease. Pack with NLGI #2.contents page for the Hi-Lo Pulleybulletins for trouble shooting.The pulleys are lubricated andrequire no maintenance.Electric motor bearings,at grease fittings on the motor.20