APPENDIX A - Valtek

More documents

Recommendations

Info

DimensionsAppendix BBody (NT11S-ST121)<strong>APPENDIX</strong> BDimensions203(7.99)113(4.45)98(3.86)218(8.58)7.5 (0.30)38.2(1.50)Unit : mm (inch)144
NT11S Installation EnvironmentAppendix C<strong>APPENDIX</strong> CNT11S Installation EnvironmentWhen installing the PT in the operation panel, observe the following points. See also the section “Getting Starting”.NoteS The view angle of the LCD screen is 35_ to the left and 35_ to the right. Install itat a position and height where operators will be able to see it well.S Do not install the unit at locations where the ambient temperature goes outsidetherange0to50_C or where the relative humidity goes outside the range 35 to85% RH.If the ambient temperature exceeds the range indicated above, install a fan oran air conditioner.LouvreFanPTControl panelS Provide sufficient space for ventilationS Do not install the unit directly above equipment that generates a lot of heat(heaters, transformers, large capacity resistors, etc.)S To ensure that the unit can be operated and maintained without difficulty, installit at a distance from high-voltage equipment and power equipment.S Install the unit as far as possible from personal computers, amateur radioequipment, radios, etc. The radio waves generated by the unit may cause interferencethat will affect these types of equipment.S Take the following points into account in order to prevent noise(1) Avoid installing the unit in panels in which high-voltage equipment is alsoinstalled.(2) Install the unit at a distance of at least 200 mm from power lines.Power line200 mm min.NT11S200 mm min.(3) If the unit is installed next to equipment that generates a strong electric ormagnetic field (solenoids, etc.), provide a gap of at least 40 mm.40 mm min.PTSolenoid145
Page 2 and 3: SpecificationsAppendix APerformance
Page 4 and 5: SpecificationsAppendix ACommunicati
Page 8: Method for Making the Cable for Con
Page 12 and 13: Method for Making the Cable for Con
Page 18 and 19: NT11S Internal ProcessingAppendix F
Page 20 and 21: Model ListAppendix GPTModelNT11S-ST
Page 22 and 23: PC Memory MapAppendix HAPPENDIX HPC
Page 24: Special CharactersAppendix IHex Dig

APPENDIX A - Valtek

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?