jack loom - Ashford Handicrafts

More documents

Recommendations

Info

20j31 Place the beater in position on the loom frame and push a 110 mm hex bolt and washer through theside Q, the front hole in the spacer blocks attached to the sides A and AX and secure with washerand nyloc nut. The two holes in the spacer blocks allow the beater to be moved forwards orbackwards to suit the weaving. See illustration 17. Do not tighten bolts. Beater must movebackwards and forwards freely.
2132 Flame the ends of the nylon cords to prevent fraying. Then tie a knot in the cords and connect thetreadles J to the parallel lams. See illustration 18.NOTE: There are four parallel lams and four slots in each treadle on the four shaft loom, and eightlams and eight slots in each treadle on the eight shaft loom. After determining the pattern required,connect the cord from each lam to the slot in the treadle directly beneath it. The knots in the cordslocate into the holes in the underside of the treadles.Illustration 19 is one of many alternative tie ups for the four shaft loom with treadles one and sixfor tabby weave.
Page 3 and 4: 3ljwkpfnexv
Page 5 and 6: Jack Loom Parts5
Page 7 and 8: 7ASSEMBLY INSTRUCTIONSASHFORD 4 & 8
Page 9 and 10: 92 Bolt castle side E to the outsid
Page 11 and 12: ILLUSTRATION 4a11
Page 13 and 14: 13h12 Secure the ratchet lever stop
Page 15 and 16: 1516 Attach the hole end of P to th
Page 17 and 18: 1723 assembly of the shaftsYour Ash
Page 19: 26 Attach the castle top rails T to
Page 23: 2333 Attach the raddle blocks to th

jack loom - Ashford Handicrafts

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?