Instruction Manual - RC World

More documents

Recommendations

Info

34Rudder57mm 57mmCuta 45bevel into the bottomleading edge of the rudder.depth3mmlength12mmSame as assembly of elevatorF ixed with some foam-friendly C/A5BracingCut the two carbon rods. One end Position the carbon rods in theof the carbon rod is fixed into the fuselage, gluing the rods to thehole of the fin with the foam vertical fuselage ONLY. This willfriendly CA and the other end is allow for alignment of the fuselagefixed into the holeofthefuselage in the next step.Make sure they are verticalSame as above stepsHold the two carbon rodstogether with a line andsome C/AIt is similar to assemble the fuselage bracing, as you want the rods to beglued to the carbonbracing that has been preinstalledon the wing and fuselage. The rods are staggered andfit intonotches in the fuselage. Make sure the rodsare straight and are not flexing the wing. Use foamfriendlyC/Ato glue the rods in position. The wingshould be flat and parallel to the horizontalstabilizer,while also being perpendicular to the vertical fuselage. Use side cutters to trim away any3
6Servosanditsconnecting bar aileronservorudderservoelevatorservoUse a dab of foam-friendly thick C/A to securethem into place.Because the size of servosdiffers, you may need to cut the servo mountinghole larger to fit your particular servos.Plywood PushrodSupportsFixed on the fuselage side boardwith some foam-friendly C/ASecure one piece of wire to one end of the carbon fiberrod, using onepiece of heat-shrink material. The pieceof wire should overlap the carbonfiber rod at least 1"(25mm). Heat the heat-shrink material with a heat gunto shrink it into place.PRO TIP For extra security, applya few drops of foam-friendly thin C/Ato the end of thepushrod and allow it to "wick" into the joint.4
Page 1 and 2: Beforeusepleasereadtheexplanationsc
Page 3: 32WingStick the carbon strips on th
Page 7 and 8: 9Landing GearF ixed with some foam-

Instruction Manual - RC World

Create successful ePaper yourself

Delete template?

Save as template?