McKINLEY EXTERIOR IMPROVEMENTS_PRODUCT ...

etaining clips made of 1/8” (0.3 cm) thick steel that shall restrain the hub/airfoil assembly in case of shaftfailure.F. Mounting System:The fan mounting system shall be designed for quick and secure installation from the structure. Allcomponents in the mounting system shall be of welded construction using low carbon steel no less than3/16” (0.5 cm) thick and powder coated or plated for corrosion resistance and appearance. All mountingbolts shall be SAE Grade 8 or equivalent.G. Safety Cable:The fan shall be equipped with a safety cable that provides an additional means of securing the fanassembly to the building structure. The safety cable shall be 3/16” (0.5 cm) diameter and fabricated out of7 x 19 stranded galvanized steel. The loops shall be secured with swaged Nicopress fittings, pre‐loaded andtested to 3,000 lb·f (13,345 N).Field construction of safety cables is not permitted.H. Controller:The fan controller shall be incorporated into the fan assembly. The controller shall be factory programmedto minimize starting and braking torques. The controller shall be equipped with a simple diagnosticprogram and an LED light to identify and relay faults in the system. The controller shall be housed in anenclosure independent of the motor to prevent overheating or electrical interference.I. Wall Control:The fan shall be equipped with a remote wall control. The wall control shall be capable of mounting to astandard electrical box and shall include operator controls and display for controlling the fan’s power andspeed. Communication with the fan drive and controller shall be by a standard (14 Ga/3 wire with ground),line voltage cable that is field installed and provided by the installer.J. Warranty:The manufacturer shall replace any products or components defective in material or workmanship, free ofcharge to the customer (including transportation charges within the USA, F.O.B. Lexington, KY), pursuantto the complete terms and conditions of the Big Ass Fans Commercial, Non‐Prorated Warranty inaccordance to the following schedule:• Airfoils Limited Lifetime (Parts)• Hub Limited Lifetime (Parts)• Motor 10 years (Parts) †• Controller 10 years (Parts) †• Labor 1 year †,†††10 year parts and 1 year labor warranties only valid with factory installation, 5 year parts without factory installation.††All reasonable costs of repair or replacement will be paid or reimbursed provided customer obtains pre‐approval; see fullwarranty for details.Further information on the terms and conditions of the warranties can be found in the Installation Guide.PART 3: ANCILLARY3.1 INSTALLATIONThe fan shall be mounted to an angle iron or I‐beam structure. Consult the Installation Guide for proper sizingand placement of angle iron for a span mount. A structural engineer must be consulted for installationmethods outside the manufacturer’s recommendation and a certification submitted prior to installation.iiBAF 3/10