HCT-SDH-155 Manual

More documents

Recommendations

Info

The display of the number, error code sec & rate of EBIT and the alarm time of LSS is available.All results aren’t controlled by the shortcut key. Real-time reception and display are availableonce in the interface. Click on the ”Stop” button to stop.6.7. Frequency Test ResultFor frequency test result, see Figure 6-8 as follows:Figure 6-8 Frequency Test Result“Rev Pat”: PRBS code pattern of the receiving part in setup menu.“Send Pat”: PRBS code pattern of the transmitting part in setup menu.“Frequency“: actual frequency for receiving, with a unit of bit/s.“Offset”: the offset between actual receiving frequency and ideal frequency (<strong>155</strong>.52Mb/s), witha unit of ppm.“Minimum“: the minimum value of the frequency measured in the interface, with a unit of bit/s.“Maximum“: the maximum value of the frequency measured in the interface, with a unit of bit/s.All results aren’t controlled by the shortcut key. Real-time reception and display are availableonce in the interface. Click on the ”Stop” button to stop.6.8. Tributary Test ResultFor tributary test result interface, see Figure 6-9 as follows:38
Figure 6-9 Tributary Test ResultThe display of tributary scan results of VC12 (E1), VC3 (E3) and VC4 (E4) (specified accordingto setup mode of the receiving part in setup menu) is available. Real-time reception and display areavailable once in the interface. Click on the “Stop” button to stop.39
Page 1 and 2: HCT-SDH/155STM1/E1 Tester
Page 3 and 4: 7. System Setup....................
Page 5 and 6: ⑴ ⑵ ⑶ ⑷ ⑸ ⑹(1) Electric
Page 7 and 8: 1.2. Introduction to Graphical User
Page 9: Figure 2-3 Configuration FileClick
Page 12 and 13: Figure 2-11 PDH Monitor Mode2.1.8.
Page 14 and 15: Figure 2-16 Mapping Mode Setup2.2.4
Page 16 and 17: LTC: loss of external clockRS: rela
Page 18 and 19: LTC: TCM frame loss alarmRDI: TCM r
Page 20 and 21: 3.3. Error Performance Analyser3.3.
Page 22 and 23: Figure 3-8 G.821 Analyzer Interface
Page 24 and 25: 4. Event RecordEvent record interfa
Page 26 and 27: “Receive value of pointer“: rec
Page 28 and 29: 4.6. Insert AlarmFor insert alarm,
Page 30 and 31: 5. Function TestFunction test inclu
Page 32 and 33: “Err Mode”:Rate (default parame
Page 34 and 35: 6. Test ResultThe test result inclu
Page 36 and 37: Figure 6-4 Pointer Test ResultPoint
Page 41 and 42: Figure 7-3 Configuration File7.1.2.
Page 43 and 44: corner to calibrate the screen as i

HCT-SDH-155 Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?