Owner's Manual - Roland

Using the VS-1680 with a CD-R/CD-RW drive+VerifyIf this is turned “On,” verification will be performed to checkwhether or not the data was saved correctly after the songdata has been backed up.CD SpeedSelect the speed at which the song data will be backed up tothe CD-RW discx2 (353 KBps): Backup at double speed (353 kilobytes persecond).x1 (176 KBps): Backup at normal speed (176 kilobytes persecond). This will increase the reliability.NOTEDepending on the disc, it may not be possible to back up reliably toa CD-R disc with a setting of “x2 (353 KBps).” In such cases,select “x1 (176 KBps).” Also, if you insert a CD-RW disc into aCD-RW drive, it will not be possible to select “x1 (176 KBps)”(backup will occur at double speed).7. If two or more drives are connected, you can press[F5 (SelDr)] to see a list of the drives. After checking thelist of drives, press [F1 (Back)].fig.5-09_7010. If you wish to save the current song, press [YES]. If not,press [NO]. If a protected song (such as a demo song) isselected, press [NO].11. If the amount of song data is too large to back up onto asingle CD-RW disc, the CD-RW disc will be ejected, andyou will be prompted to “Insert Disc #” (where # isnumber of each disc in the series), so that the VS-1680 canverify the number of discs that will be required. Insertthe next CD-RW disc, and press [YES]. At this time, werecommend that you use a soft-tipped felt marker pen towrite the disc number on the disc label so that you canremember the sequence in which each disc should beinserted.fig.5-1112. If the backup extends over two or more discs, the displaywill prompt you to “Insert Disc #.” Insert each disc onceagain in the correct sequence, and press [YES]. Then,backup will begin.13. When the CD-R backup ends, you are returned to Playcondition.Restoring songs from aCD-RW disc (Recover)Specifying the speed ofrecovery (Speed)Now you can specify the speed at which the data will be readwhen recovering a song from a CD-RW disc.Recovery procedure8. Press [F4 (Exec)]. A message will ask you to confirm.fig.5-101. Select the loading destination (recovery destination)drive as the current drive.2. Insert the CD-RW disc that contains the song backup intothe drive.3. Press [PLAY (DISPLAY)].4. Hold down [SHIFT] and press [F6 (UTILITY)].9. Press [YES]. The display will ask “STORE Current?”(store the current song?)28