Wadkin PP Panel Dimension Saw Manual and Parts List

WadKin OPERATING AND MAINTENANCE INSTRUCTIONSThe ripping fence is initially pitched. 004" this is measured at the front and rear of the saw,w'ith UH~' 1,f,ii.~iW r:l~llf 1!"~~j~f.~!d, The' dlir:n~mi!ili~Gm at the rear of the saw being . 004" greaterU1!j~;,n ~~.t the front of the saW. Should this pitching require'iLUiE!i!~i!.ng the grubscrew locking the eccentric pivot pin,~lh:m~lid be slackened off and the eccentric pivot pin turned:!:i!;} j~l:1:i to increase or decrease the pitching.Fig. 9.~J.:"~:), ~~,djust the fence pointer measure dimension betweenl:iu:"t.: 4:d' saw nearest fence and fence plate, then slackenfJ~'f F.,().inter locking grubs crew , set pointer to dimensiono1i:J.;taiJl'Y,ed between Saw set and fence, lock pointer in~1(J;s.;i,Ul[)n.oom:3,LE MITRE FENCE. Fig. 8. is in two parts1:J.ut.hnn.ade to pivot from a central pin fixed in.§:U.dhujg table. Degree angles are marked on thet.:1lb~,~ for accurately setting the fences, the principalanli!i]~~a being positively located by spring plunger.MUl:"~~s can be cut giving accurately squared frames'ii'fl;h(!:ji~ asSembled a bar and stop determines the exactl!E!in~:th of material cut off. Front leaf is supplied as.If:'i;n:~.l]ldard, rear leaf optional extra.C'r.'Olllf.!!: cutting fence Fig. 9. is used for both square:ili,ndi ~~,ngular work and can be used either side of theI:!l~~:~~ hl the table grooves. A bar and stop determines1;~,~~,~:;:t length of material cut off. ThiS fence is anopU!:).'nal extra.www.wadkin.cominfo@wadkin.comPage 9