**S2-125 내지060930

SIDE STAND INSPECTIONErect main stand and place vehicle inupright position on level ground.Check the spring for damage or loss oftension and the side stand assembly forfreedom of movement.Check the side stand ignition cut-offsystem;Put the side stand up.Start the engine.Lower the side stand. The engineshould stop as you put the side standdown.If the side stand system does notoperate as described, inspect it in theclosest authorized repair center.CABLE RUBBER PARTA rubber boots is assembled on the cableto protect the inner cable.Make sure that this part is placed firmlyaround the correct part of the cable. Whenwashing the vehicle, do not directly spraywater on to the rubber boots or scrub itwith brush. Use a dry cloth to clean thisarea.Check the installing condition of rubberboots daily. After adjusting the free playof throttle grip, never forget to place therubber boots to the original position.WARNINGInfiltration of the foreign materials orwater caused by damage of rubberboots (disengagement, tearing, etc.)may cause freezing in winter seasonresulting in faulty operation. It maylead death or serious injury bydecreasing of sudden acceleration andbraking force due to engine rpm.If any damage is found, replace with thenew on immediately.45