Covered Task - Kinder Morgan

A. Be aware that all Company health and safety (safe work permit) guidelines must be met prior to commencement of work.B. Be aware of OQ qualification requirements for draindown and/or blowdown prior to removal of any pipeline components (Covered Tasks 104.17, 104.18 and/or104.19).C. Be aware of Company procedures for de-energizing and energizing rectifiers in affected area.D. Be aware of bonding and grounding requirements while work is being performedE. Know which Company personnel are to be notified of potential requirement for cathodic connection of disconnected pipe.F. Be able to safely disconnect component from pipeline systemG. Be able to recognize and respond to abnormal operating conditions that might be encountered when performing this covered task.104.21 Welding on existing pipeline systemsA. Be aware that all Company health and safety guidelines (safe work permit, hot work permit) must be met prior to commencement of work.B. Be aware of Company policies for working in an excavation and for safe work permittingC. Be able to verify current Company welding qualificationD. Be aware of the following DOT guidelines and restrictions on:1. Welding of supports and braces2. Miter joints3. Repair of arc burns4. Repair or removal of weld defects5. Weather conditions during weldingE. Be able to have on site and use proper welding equipment (welding helmet and eye shield, gloves, etc.)F. Be aware that pressure limitations may be required when welding on the pipeline, and be able to obtain those limitations from the proper Operations personnel.G. Be aware of OQ qualification requirements for determining thickness of pipe (Covered Task 104.03) prior to commencement of welding on pipe.H. Be aware that a fire watch is required during the welding activity.I. Be aware that proper ventilation is required in work area.J. Be aware of OQ qualification requirements for inspection of welding and non-destructive testing on welds (Covered Tasks 103.12 and 103.13).K. Be able to visually inspect work area for leakage upon completion of work.L. Know proper documentation requirements.M. Be able to recognize and respond to abnormal operating conditions that might be encountered when performing this covered task.104.22 Locate PipelineA. Locate line1. Be able to read information on pipeline drawings (engineering vs continuous stationing, station numbering, legends, scaling, depth where available)2. Verify line section being located.3. Be able to use specific linefinder according to manufacturer’s operating instructions.4. Be knowledgeable in local conditions to ensure linefinder readings are within the expected range.5. Physically locate the pipeline, using probing tool as necessary.6. Disconnect cathodic protection bonds as needed to eliminate confusion if several pipelines are bonded together.B. Be able to recognize and respond to abnormal operating conditions that might be encountered when performing this covered taskPage 25 of 33