TE 2000 Terminal Emulation Programmer's Guide VT/ANSI

Chapter 1 —Getting StartedPerforming a Quick ConfigurationNote: For Terminal Emulation Version 6.60 or greater, the default datastream is “VT/ANSI.”1 Change the data stream to VT/ANSI. The default data stream is “Native”for the 6400 (WTP), 5055 (WTP), 59XX, 17XX, and 11XX Terminals,.The default data stream for 2415, 2425, 2435A, 2455, 2475,248X, and IP terminals is “3270.”a Access the terminal emulation configuration menus by pressing thefollowing keys, then choose 1) Set-up Parms from the Main Menu.TerminalKey Sequence2415 )!(55-key keyboard)(5(37-key keyboard)2425 (!2435Arl(57-key keyboard)[Green] > [Orange] > (48-key keyboard)rl(39-key function numeric keyboard)2455, 2475, 248X (¡6400 [Gold] [Blue]5055 [Blue] [M] or [ALT] [M]59XX17XX, 11XX[Brown] [Space][Gold] [Black]Note: Press a number to select a menu option, then press [Enter] toreturn to a previous menu.b At the Enter Password prompt, enter cr52401.On 17XX (37-key) Terminals, the password is: F12F1152401c From the Set-up Parms menu, select 3) Protocol Opts,2) Data Stream, then4) VT/ANSI.2 Extended commands transmit or receive data over the terminal’sRS-232 port, send information to an RS-232 device, or collect data. Enablethe Extended Cmds option if your host computer is configured tosend extended commands to the terminal. It is disabled by default.From the Protocol Opts menu, select 3) Extended Cmds, then1) Enabled.3 From the Main Menu, select 7) More, then2) Save Parms.4 At the Enter Password prompt, type cr52401, then press enter.On 17XX (37-key) Terminals, the password is: F12F11524015 From the Main Menu, select 6) Exit Menus.Note: For WTP devices, you should also set a terminal number.6 Log in to a TE session, then use the terminal to collect/transmit data.4 TE 2000 VT/ANSI Terminal Emulation Programmer’s Guide