SAS/ACCESS 9.2 for Relational Databases: Reference, Fourth Edition

228 BL_DB2MGMTCLAS= Data Set Option 4 Chapter 11All valid data sets that the utility accepts are supported whenBL_DB2LDEXT=USERUN. However, syntax errors from the utility can occurbecause no parsing is done when reading in the SYSIN data set. Specifically, neitherimbedded comments (beginning with a double dash ’–’) nor columns 73 through 80 ofRECFM=FB LRECL=80 data sets are stripped from the control statement. Thesolution is to remove imbedded comments and columns 73 through 80 of RECFM=FBLRECL=80 data sets from the data set. However, this is not an issue when you useengine-generated SYSIN data sets because they are RECFM=VB and therefore haveno imbedded comments.DetailsTo specify this option, you must first set BULKLOAD=YES .This option specifies the mode of execution for the DB2 LOAD utility, which involvescreating data sets that the utility needs and to call the utility.See Also“BULKLOAD= Data Set Option” on page 290BL_DB2MGMTCLAS= Data Set OptionSpecifies a management class for a new SMS-managed data set.Default value: noneValid in: DATA and PROC steps (when accessing DBMS data using SAS/ACCESSsoftware)DBMS Support: DB2 under z/OSSyntaxBL_DB2MGMTCLAS=management-classDetailsThis option applies to the control file (BL_DB2IN), the input file (BL_DB2REC), and theoutput file (BL_DB2PRINT) for the bulk loader. Use this option to specify amanagement class for a new SMS-managed data set. If SMS is not installed or active,the operating environment ignores any management class that BL_DB2MGMTCLAS=passes. Your site storage administrator defines the management class names that youcan specify when you use this option.For sample code, see the “BL_DB2STORCLAS= Data Set Option” on page 233.See Also“BL_DB2DATACLAS= Data Set Option” on page 222“BL_DB2STORCLAS= Data Set Option” on page 233“BL_DB2UNITCOUNT= Data Set Option” on page 236“BULKLOAD= Data Set Option” on page 290