SAS/ACCESS 9.2 for Relational Databases: Reference, Fourth Edition

Data Set Options for Relational Databases 4 BL_WARNING_COUNT= Data Set Option 287Valid in: DATA and PROC steps (when accessing DBMS data using SAS/ACCESSsoftware)DBMS support: HP Neoview, Netezza, Oracle, Sybase IQSyntaxBL_USE_PIPE=YES | NOSyntax DescriptionYESspecifies that a named pipe is used to transfer data between SAS/ACCESS interfacesand the DBMS client interface.NOspecifies that a flat file is used to transfer data.DetailsBy default, the DBMS interface uses a named pipe interface to transfer large amountsof data between SAS and the DBMS when using bulk load or bulk unload. If you preferto use a flat data file that you can save for later use or examination, specifyBL_USE_PIPE=NO.HP Neoview: To specify this option, you must first set BULKEXTRACT=YES. Thisoption determines how to the sources section of the control file are set up and themethod that is used to transfer or receive data from the HP Neoview Transporter. Inparticular, its setting helps you choose which specific source to select. The default valueis YES.Netezza: To specify this option, you must first set BULKLOAD=YES orBULKUNLOAD=YES. The default value is YES.Oracle: To specify this option, you must first set BULKLOAD=YES orBULKUNLOAD=YES. The default value is NO.Sybase IQ: To specify this option, you must first set BULKLOAD=YES. The defaultvalue is YES.See Also“BL_DATAFILE= Data Set Option” on page 218“BULKEXTRACT= LIBNAME Option” on page 102“BULKEXTRACT= Data Set Option” on page 289“BULKLOAD= Data Set Option” on page 290“BULKUNLOAD= LIBNAME Option” on page 103“BULKUNLOAD= Data Set Option” on page 291BL_WARNING_COUNT= Data Set OptionSpecifies the maximum number of row warnings to allow before the load fails.Default value: 2147483646