real-time image capturing system for car plate recognition

3System decreases if the quality of input image decreases with the video quality. Thequality of video turn worst if there are any disturbances factors such as lightreflection and other exist during the real-time video recording process [3].1.2 ObjectiveThe objectives of this project as following:-To develop an application that can integrate the camera with the board sothat it is able to receive the video signal and display it through the board.To display a clear and smooth quality real-time streaming video throughdeveloped application compared to the quality of video that view byusing web browser.To capture and save images of car plate from the real-time streamingvideo.1.3 ScopeFirst and foremost, the project will be 100% programming and will notinvolve in any hardware design. The Basler IP camera BIP2-640c must be able tointegrate with the Intel Desktop Board D525MW. An application is designed mainlyto stream out the real-time video signal seen by the IP camera lens. The IP camerawill be setup at the main exit location of Universiti Teknologi Malaysia to record thereal-time video of vehicle flow-out from the university. Due to the limitation of thesetup place, the IP camera will record the video right in front of vehicle which isperpendicular to the IP camera view with ±20°offsets. The real-time video will berecorded in any situations, either day time or night time, sunny or raining weather.Video input of IP camera will be set at the rate of 30 frames per second so that theimage processing to recognise the car plate can be done as fast as possible. Inaddition, the real-time video signal will be able to be streamed out through the