OC-48 LR-2/STM16 L-16.2 SFP Transceiver - Source Photonics

OC-48 LR-2/STM16 L-16.2 SFP TransceiverSP-48-LR2Transmitter Specifications , ElectricalParameter Symbol Min Typical Max UnitInput Differential Impedence R in 80 100 120 ΩPECL Single Ended data input swing V in, p-p 250 - 1200 mVTxFault_Fault V fault 2 - V cc VTxFault_Normal V normal V ee - V ee + 0.5 VTxDisable_Disable V d 2 - V cc VTxDisable_Enable V en V ee - V ee + 0.8 VReceiver Specifications, OpticalParameter Symbol Min Typical Max UnitReceiver Power Lowe R sens,low - -30 -28 dBmReceiver Power High e R sens,high -6 - - dBmDamage Threshold for Receiver P in, damage 4 - - dBmWavelength f λ 1500 1550 1580 nmMaximum Reflectance of Receiver RX_r - - -27 dBLOS Assert - -42 - - dBmLOS De-assert - - - -28 dBmLOS Hysteresis - 0.5 - - dBe) At 10 -10 BER, PRBS 2 23 -1f) Operational over 1200-1625 nm rangeElectrical OutputParameter Symbol Min Typical Max UnitPECL Single Ended Data Output Swing V out,p-p 185 - 800 mVData Output Rise Time t r - - 175 psData Output Fall Time t f - - 175 psLUMINENTOIC.COM20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.94869F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.51692132LUMNDS1525-FEB1706rev.A.0

OC-48 LR-2/STM16 L-16.2 SFP TransceiverSP-48-LR2Timing and ElectricalParameter Symbol Min Typical Max UnitTx Disable Negate time t_on - - 1 msTx Disable assert time t_off - - 10 µsTime to initialize, including reset of Tx fault t_init - - 300 msTx fault Assert time t_fault - - 100 µsTx Disable to reset t_reset 10 - - µsLOS Assert time t_loss_on - - 100 µsLOS De-assert time t_loss_off - - 100 µsSerial ID Clock Rate f_serial_clock - - 100 KHzRX_LOS Voltage (high) Rx_LOS H 2 - - VRX_LOS Voltage (low) RX_LOS L - - 0.8 VLOS output voltage-Fault V LOS fault 2 - V cc VLOS output voltage-Normal V LOS normal V ee - V ee + 0.5 VMOD_DEF (0:2)-High V h 2 - Vcc VMOD_DEF (0:2)-Low V I V ee - V ee + 0.5 VDiagnosticsParameter Range Accuracy Unit Calibration FormulaTemperature(-CDx) -5 to 70 ±3 ºC Internal Tc(C) = Tad(16 bit signed twos complement)/256Temperature(-RDx) -20 to 85 ±3 ºC Internal Tc(C) = Tad(16 bit signed twos complement)/256Voltage 0 to Vcc 0.1 V Internal V(Volts) = Vad(16 bit unsigned integer)*0.1Bias Current 0 to 120 5 mA External I(mA) = Islope * Iad(16 bit unsigned integer)+IoffsetTx Power -2 to 3 ±3dB dBm ExternalTx_PWR(µW) = Tx_PWRslope*Tx_PWRad(16 bit unsigned integer)+Tx_PWRoffsetRx Power -32 to -6 ±3dB dBm External Rx_PWR(µW) = A0+A1*x+A2*x^2+A3*x^3+A4*x^4LUMINENTOIC.COM20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.94869F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.51692133LUMNDS1525-FEB1706rev.A.0

OC-48 LR-2/STM16 L-16.2 SFP TransceiverSP-48-LR2EEPROM Serial IDName of Field Discription of Field Address Hex ASCII20 4C L21 55 U22 4D M23 49 I24 4E NVendor NameSFPVendor name (ASCII)25 45 E26 4E N27 54 T28 4F O29 49 I30 43 CVendor OUIIEEE vendor OUI code for LuminentOIC Inc.37 0038 0639 B5Vendor PNPart number in ASCII, e.g.SP-48-LR2-CDA40 53 S41 50 P42 34 443 38 844 4C L45 52 R46 32 247 43 C48 44 D49 41 APinout DefinitionsPin Function Notes1 V ee T TX GND2 TX_FAULT Open Collector3 TX_DISABLE Internally Pulled High4 MOD_DEF2 Serial Data Input5 MOD_DEF1 Serial Clock Input6 MOD_DEF0 Internally Grounded7 NC Not Connected8 LOS Open Collector9 V ee R RX Ground10 V ee R RX Ground11 V ee R RX Ground12 RXD- RX Data Negative13 RXD+ RX Data Positive14 V ee R RX GND15 V CC R RX Power16 V CC T TX Power17 V ee T TX GND18 TXD+ TX Data Positive19 TXD- TX Data Negative20 V ee T TX GNDLUMINENTOIC.COM20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.94869F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.51692134LUMNDS1525-FEB1706rev.A.0

OC-48 LR-2/STM16 L-16.2 SFP TransceiverSP-48-LR2Outline DrawingUnits in mm(inch)Suggested Transceiver Interface1µHProtocol ICTX_DISABLEV CCR 110 µF0.1µF1µH.01µFTX_DISABLEVCC T10kΩLuminentOICTX_FAULTSerDesTX_FAULTTD +.01µFLaser Driver100ΩTD -.01µFVEE TVCC R10µF0.1µFRD +.01µFReceiver Amplifier100ΩRD -RX_LOSRX_LOS.01µFV CCR 1 R 1 R 1R 1VEE REEPROMMOD_DEF 2MOD_DEF 1MOD_DEF 0R 1 = 4.7Κ to 10ΚΩLUMINENTOIC.COM20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.94869F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.51692135LUMNDS1525-FEB1706rev.A.0

OC-48 LR-1/STM16 L-16.2 SFP TransceiverSP-48-LR2Ordering InformationAvailable Options:SP-48-LR2-CDASP-48-LR2-CNASP-48-LR2-RDASP-48-LR2-RNAPart numbering Definition:SP - 48 - LR2 - Temperature Diagnostic Revision• SP = Small Form Pluggable48 = OC48LR2 = Long reach 80km• Operating TemperatureC = Commeracial (-5 to 70)R = Reduced Industrial (-20 to 85)• D = Digital DiagnosticN = No Digital Diagnostic• Design RevisionWarnings:Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Followguidelines according to proper ESD procedures.Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation.Legal Notes:IMPORTANT NOTICE!All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performanceof its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” aregiven to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties,warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions ofSale for further warranty information.LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectualproperty described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makesno representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this documentare NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customersusing or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting fromsuch use or sale.THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for anyactual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contactLuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current.© LuminentOIC, Inc. 2003All rights reservedLUMINENTOIC.COM20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.94869F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.51692136LUMNDS1525-FEB1706rev.A.0