Model 24926 - Ready Remote

Following is a brief description of the remainder of the wires inthe H2 harness. For specific details on connecting these outputscontact Technical Support at 1-800-477-1382.Horn/siren wireThe Blue wire provides an output for activating the vehicle horncircuit or an external siren. The output is programmable in FeatureMenu 1/9 for the desired use.The Brown wire is designed to turn off accessories that remain onafter the ignition is turned off. It will pulse 10 seconds after theremote start status output ceases and will make the vehicle bodycontrol module think the door has opened, thus turning the accesimportant!This is a low current output and thatrequires an external relay when connected to circuitsthat draw more than 400mA in current.Wait-to-start wireThe Red/Black wire is for use with diesel engines that require ashort delay for the glow plugs to warm up before cranking theengine. Connect this wire to the wire in the vehicle that sends thesignal to turn on the WAIT-TO-START bulb in the dashboard. Inmost diesels the wire is negative (ground turns on the bulb) andthe Red/Black wire can be directly connected. If the vehicle usesa positive wire (12V to turn on the bulb) a relay must be used tochange the polarity.Ignition Output wireThe Yellow/Green wire should be the ONLY the ignition input to anexisting aftermarket alarm system. This wire will prevent the hostsystem from sensing that the ignition is on during remote startoperation.RAP or Retained Accessory Power26 © 2006 Directed Electronics