VENTURA 150 DELUXE INSTALLATION MANUAL

Product Water and Pressure Gauge Tube InstallationSampling Tap for testing the productwater or for service procedures.Put enough tube on this port to reachyour service (pickling) container.Route the product water from the valveinto the top of the tank. Install a tee inthe water fill or tap a pipe thread intoan inspection port.Product to tank.DO NOT! feed the product into a ventline, manifold or the bottom of the tank.Make sure that there is no restriction inthis piping. Pressure in the producttubing must never exceed 5psi (.3bar)at any time, (running or stopped) or themembrane will be permanently damaged.Product sampling valve. Mount using the suppliedplastic straps as shown.Note: the handle is pointing in the direction of theflow.Use accumulator port to connect the pressuregauge. Use the supplied 1/4” black nylon tubing.If other tubing is used it must be pressurerated to 150 PSI (10 BAR)Pressure GaugeProduct Flow meterPlastic fittings should have 3-4 wraps of Teflon tape andwill thread almost all the way in. Leave the first pipe threaduncoated. Avoid getting dirt or debris in the system duringassembly. Secure piping away from moving objects andprotect from chafe. Exercise care not to cross thread thefittings. See the tube assembly instructions next page.Back view of instrument panel.Use the supplied 1/4”black nylon tubing forthe product plumbingProduct Ports arelocated hereRemove one of the product port plugs (from either end) andthread in the product fitting with Teflon tape sealant.Product fitting8