Download Commander II Instruction Manual PDF file

91735KG91735KGLOCKLIGHTProgrammingNOTICE: If this SAFETY SIGNAL TM garage door opener is operated with a non-rolling code transmitter, the technical measure in thereceiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of thecopyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent thattechnical measure.Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door willopen and close when you press the large push button.Below are instructions for programming your opener to operate with additional SAFETY SIGNAL TM 315MHz remote controls.To Add and Reprogram an Additional Hand-held Remote ControlUsing the “Learn” ButtonUsing the Multi-Function Door Control1. Press and release the “learn” button onthe motor unit. The learn indicator lightwill glow steadily for 30 seconds.1. Press and hold the button on the handheldremote* that you wish to operateyour garage door.2. Within 30 seconds, press and hold thebutton on the hand-held remote* that youwish to operate your garage door.3. Release the button when the motor unitlights blink. It has learned the code. Iflight bulbs are not installed, two clickswill be heard.2. While holding the remote button, pressand hold the light button on the Multi-Function Door Control.3. Continue holding both buttons while youpress the push bar on the Multi-FunctionDoor Control (all three buttons are held).4. Release buttons when the motor unitlights blink. It has learned the code. Iflight bulbs are not installed, two clickswill be heard.LOCKLOCKLIGHTLIGHTTo Erase All Codes From Motor Unit MemoryTo deactivate any unwanted remote, firsterase all codes:Press and hold the “learn” button on motorunit until the learn indicator light goes out(approximately 6 seconds). All previouscodes are now erased. Reprogram eachremote or keyless entry you wish to use.*3-Button RemotesIf provided with your garage door opener, the large button isfactory programmed to operate it.Additional buttons on anySAFETY SIGNAL TM 3-buttonremote or mini-remote can beprogrammed to operate otherSAFETY SIGNAL TM garagedoor openers.31