CD80 Advanced Electronics Rack User Manual - The Strand Archive

More documents

Recommendations

Info

InstallationChapter4PreparationBefore installing your CD80 Racks, you should carefully consider theenvironment in which the equipment is to be installed, the power feedingthe equipment, and the required conduit and/or cable runs.EnvironmentalConsiderationsTo maximize equipment life, and minimize the chance of failures, thefollowing environmental requirements should be met:Temperature -- 40°C (104°F).Humidity -- 5%-80% relative humidity maximum, no condensation.CautionDimmer rack efficiency is at least 95%. Since the remainder of theenergy is dissipated as heat, they should be installed in a room withadequate ventilation to dissipate a heat load equivalent to 5% of themaximum load the dimmer racks will handle.Power RequirementsWarningA three phase power source (120VAC 50/60Hz for 120VAC units or220VAC 50/60Hz for 220VAC units) must be provided for dimmer andCommand module power. Please consult Strand Lighting on the actualmain feed size required for specific installations.Do not install this equipment with power applied. Make sure that yourincoming power is disconnected before proceeding.Do not provide a 220VAC power to a 120VAC dimmer rack, or a120VAC power to a 220VAC dimmer rack, as damage may result.When ordering spare parts or replacements, make sure you specify therequired voltage.Installation 13
Plan Conduit LayoutThe location of conduit runs and their entrance to the dimmer cabinet isimportant and should be carefully planned before cutting holes orattaching conduit. Figure 2 shows the allowed entry areas for the varioustypes of wiring.Figure 2. Conduit Entry Areas14
Page 2 and 3: Introduction and AssistanceChapter1
Page 4 and 5: ConventionsThe following additional
Page 6 and 7: Operational FeaturesChapter2This ch
Page 8 and 9: Hardware DescriptionChapter3The CD8
Page 10 and 11: Input Processor ModuleThe Input Pro
Page 12: Quiet DimmersFor locations where no
Page 17 and 18: Figure 3. CD80 Dimmer ReceptacleCon
Page 19 and 20: Each rack has its own OverTemp sens
Page 21 and 22: Wire Version 1Command Module(s)Inst
Page 23 and 24: Close Up RackThe rack can be closed
Page 25 and 26: Input Processor ModuleServicingThe
Page 27 and 28: Problems Affecting theEntire RackTo
Page 29 and 30: Dimmers for one phase will not go t
Page 31 and 32: Dimmer ProcessorCard CalibrationThe
Page 34: Figure 13. CD80 Rack Back Panel Par
Page 38: Figure 15. CD80 6Kw Dimmer ModuleBa
Page 42: Periodic MaintenanceChapter6Periodi

CD80 Advanced Electronics Rack User Manual - The Strand Archive

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?