CD80 Advanced Electronics Rack User Manual - The Strand Archive

More documents

Recommendations

Info

wire). Do not use this cable for runs greater than 100 feet. All other runs(in or out of conduit) are made with Belden #9156 (2 pairs of unshielded18 gauge wire). The maximum allowable distance from the control consoleto the last dimmer cabinet is 1000 feet.Figure 6. AMX192 Extension CableConnect DMX512 Dimmer Control WiringThe two types of connections provided in Strand Lighting equipment forDMX512 dimmer control signals are the XLR style connector and terminalblocks. Unless otherwise specified, dimmer cabinets use terminal blockconnections and consoles use XLR style connectors (see table 3).Table 3. DMX512 Control InputsCable: Belden 9829 or equal.Max Length: Standard RS485 electrical characteristics apply, including linedriver and receiver characteristics, line loading, and multi-dropconfigurations.Connector: Terminal block in fixed cabinets and racks. "XLR" styleconnector on moveable racks and packs, and on control consoles.XLR Terminal DMXPairs WirePin # Label Signal CommentsColor1 D-GND COMMON Dimmer Common (shield) shield2 DATA- OUT DATA 1- Dimmer Drive Complement pair 1 black3 DATA+ OUT DATA 1+ Dimmer Drive True red4 Not used DATA 2- Optional #2 Data Link Complement pair 2 black5 Not used DATA 2+ Optional #2 Data Link True whiteDATA 1- and DATA 1+ are one twisted pair. Common is tied to thecable shield.Figure 7. DMX512 Dimmer Control Extension CableInstallation 19
Wire Version 1Command Module(s)Install the Command Module/Fan assemblies as shown in figure 8.Figure 8. Command Module Wiring20
Page 2 and 3: Introduction and AssistanceChapter1
Page 4 and 5: ConventionsThe following additional
Page 6 and 7: Operational FeaturesChapter2This ch
Page 8 and 9: Hardware DescriptionChapter3The CD8
Page 10 and 11: Input Processor ModuleThe Input Pro
Page 12: Quiet DimmersFor locations where no
Page 15 and 16: Plan Conduit LayoutThe location of
Page 17 and 18: Figure 3. CD80 Dimmer ReceptacleCon
Page 19: Each rack has its own OverTemp sens
Page 23 and 24: Close Up RackThe rack can be closed
Page 25 and 26: Input Processor ModuleServicingThe
Page 27 and 28: Problems Affecting theEntire RackTo
Page 29 and 30: Dimmers for one phase will not go t
Page 31 and 32: Dimmer ProcessorCard CalibrationThe
Page 34: Figure 13. CD80 Rack Back Panel Par
Page 38: Figure 15. CD80 6Kw Dimmer ModuleBa
Page 42: Periodic MaintenanceChapter6Periodi

CD80 Advanced Electronics Rack User Manual - The Strand Archive

Create successful ePaper yourself

Delete template?

Save as template?