ODMS (Error Messages) - ABB SolutionsBank

ERROR MESSAGES AND RECOVERYTable 7-3. ICI Error Codes (continued)Value Reply Code Meaning/Possible Corrective Action44 ICI_INV_WALLCLOCK Wall clock time is not valid. Error returned when the ICI isrestarted with time stamps enabled and adding the wallclock offset enabled but the ICI has not received a timesynch message from either the host computer or the INFI90 OPEN system.100 ICI_UND_MESS_TYPW Undefined message type.101 ICI_BUSY Module is busy, cannot reply.102 ICI_MODE_CONFLICT Module mode conflicts with command.103 ICI_ILL_DATA Illegal message data.104 ICI_INV_BLK_NUM Function block is not valid.105 ICI_UND_BLK_NUM Function block is not configured.106 ICI_BLK_NOT_READ Function block has no readable parameters.107 ICI_INV_FUNC_CODE Invalid function code specified for module.108 ICI_FUNC_BLK_MISS Function code and block number not compatible.109 ICI_INS_MEM Insufficient memory in module to write block.110 ICI_MOD_NOT_RESP Module is not responding.128 ICI_WAIT_MOD_REP Waiting for module reply.200 NO_SEC_DEV_PRESENT Software key does not exist on the termination unit.201 RETRY_COMMAND Retry the open data access client command. Refer to theappropriate open data access client instruction for moreinformation.202 INVALID_API_DETECTED INFI 90 OPEN communication module detected an invalidopen data access client command attempting to access theINFI 90 OPEN system. Refer to the appropriate open dataaccess client instruction for more information203 WAIT_AND_RETRY_COMMAND Wait one second and try the open data access client commandagain. Refer to the appropriate open data access clientinstruction for more information204 INVAL_SEC_DEV_PRESENT INFI 90 OPEN communication module has detected a softwarekey but it is invalid.301 ICI_GMISTATUS_BUSY MFP or file is in use.302 ICI_GMISTATUS_BUSY No buffers available.303 ICI_GMISTATUS_SMALL Buffers are too small.304 ICI_GMISTATUS_NOT_OPENED MFP file or buffer is not open.305 ICI_GMISTATUS_WRITE_PROT File is write protected.306 ICI_GMISTATUS_OFFSET_OUT Offset is out of range.307 ICI_GMISTATUS_OPENED File is already open.308 ICI_GMISTATUS_INV Invalid operation.309 ICI_GMISTATUS_MODE Wrong mode specified.310 ICI_GMISTATUS_ERRORIN File has an error in data.311 ICI_GMISTATUS_EXIST File does not exist.313 ICI_GMISTATUS_UNABLE Could not create file.ERROR MESSAGESWBPEEUI350003B0 7 - 25