ZIG-2400 Series - Vespo.pub

ZIG-2400 SeriesSpecificationsPage 2Zig-24002400-RB (Base/Router)Communications: RS232, RS422, RS485Wireless standard: IEEE 802.15.4-2006Wireless range: 100m typical line of sightDuty:Configurable as Base or RouterEmbedded protocol support: MODBUS RTU plus MicroScandefault ACSIIPower Supply: 12~24VdcPower consumption: 5 VAZig-24002400-TCPTCP-MODBUSCommunications: MODBUS TCPWireless standard: IEEE 802.15.4-2006Wireless range: 100m typical line of sightDuty:BaseEmbedded protocol support: MODBUS TCPPower Supply: 12~24VdcPower consumption: 5 VAZig-24002400-SleeperNumber of temperature channels: 2External temperature sensors: Pt100, Pt1000Selectable Temperature ranges: Within -200C to 850CWireless standard: IEEE 802.15.4-2006Wireless range: 100m typical line of sightEmbedded protocol support: MODBUS RTU plus MicroScandefault ACSIIBattery life: Approx 2 years life when wake upinterval set to 2 minutes.Optional external Power Supply: 12~24VdcOption to switch from Sleeper mode to permanently online.Zig-24002400-TCPTCP-ACSIICommunications: ASCIIWireless standard: IEEE 802.15.4-2006Wireless range: 100m typical line of sightDuty:BaseEmbedded protocol support: MicroScan default ASCIIPower Supply : 12~24VdcPower consumption: 5 VARS232/485LANZig-2400-RB100m ** Line of sight.Zig-2400-RB2100-A16Remote StationZig-2400-RB2100-A16RemoteStationZig-2400-SleeperShimadenControllerZig-2400-RBTemperatureProbesPowered by batteries or plug pack.Batteries have approx 2 years lifewhen wake up interval set to 2 mins.2100-A16Zig-2400-RB2100-A16Phone:Fax:1-800-49-VESPO or 1-239-348-80861-800-36-VESPO or 1-239-348-9910Product Liability. This information describes our products. It does not constitute guaranteed properties and is not intended to affirm the suitability of a product for a particular application. Due toongoing research and development, designs, specifications, and documentation are subject to change without notification. Regrettably, omissions and exceptions cannot be completely ruled out. Noliability will be accepted for errors, omissions or amendments to this specification. Technical data are always specified by their average values and are based on Standard Calibration Units at 25C,unless otherwise specified. Each product is subject to the ‘Conditions of Sale’.Warning: These products are not designed for use in, and should not be used for patient connected applications. In any critical installation an independant fail-safe back-up systemmust always be implemented.controls@vespo.com>> www.vespo.com