Banks Six-Gun® Diesel Tuner - Bankspower - Banks Power
Banks Six-Gun® Diesel Tuner - Bankspower - Banks Power
Banks Six-Gun® Diesel Tuner - Bankspower - Banks Power
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 3Installation of the (Optional) <strong>Six</strong>-Gun Selector SwitchNot needed if the optional <strong>Banks</strong> iQ isinstalled.CAUTION: Do not use forcewhen working on plastic parts.Permanent damage to the partmay result.Note: Before drilling, confirm thatthere is adequate room for the Switchand wires behind the dash. Make surewires or obstructions are cleared fromthe drilling area.From where the <strong>Six</strong>-Gun Switch willbe located, make sure there is enoughwire on the In-Cab Cable to reach theSwitch.1. The <strong>Six</strong>-Gun Switch can be installedon the driver’s side of the instrumentpanel (IP) to the left side of thesteering column. There are two dashtypes: Dash 1 (Figures 11, 12) andDash 2 (Figures 13, 14).Note: These are just suggestedlocations. It is possible to locatethe <strong>Six</strong>-Gun Switch where it is morecomfortable. Please confirm spacebehind dash before drilling.2. To install on the driver’s side IP(Dash 1, Figure 11):Pull the IP trim out by pulling the topedge above the vent as shown inFigure 15. Disconnect any switchwires.3. Cut out the supplied template,Figure 25, and align the dashed linesto the edge of the IP where you wouldlike to mount the Switch. Tape thetemplate in place. Continue to Step 7.4. To install the Switch to the left sideof the steering column (Dash 2 Figure14):Figure 11 Figure 1214 96819 v.3.0
Change language