Banks Six-Gun® Diesel Tuner - Bankspower - Banks Power

9. From inside the cab locate thegrommet on the firewall and makeanother 1” x 1” cross-shaped (X) incisionon the grommet, opposite the spot thatwas cut from the outside. Now, feed theIn-Cab cable through the incision madein the firewall grommet and into the cab(Figure 5).Note: Some thick putty may be usedto provide additional sealing around theIn-Cab cable and the grommet.10. Position the Tuner on the fuse boxcover for an idea of where to clean. TheTuner must be mounted as close to theinside (engine side) edge as possible toavoid a hood clearance issue. Checkthe hood clearance before attachingthe Tuner to the fuse box. Clean the topof the fuse box cover located on thedrivers’ side of the engine compartment.Make sure the outside of the fuse box isfree of oil, grease and dirt.Note: Clean the fuse box cover with anon-oil based solvent such as Acetone,Mineral Spirits, Denatured Alcohol orLacquer Thinner. Read and follow themanufacture’s operation instruction fornon-oil based solvent cleaner.Figure 5WARNING: Make sure to place theTuner as shown in Figure 2 to avoida clearance issue when closing thehood. Mount the Six-Gun Tuner asclose to the inside (engine side)edge of the fuse cover as possible.Verify you have hood clearancebefore mounting the Tuner.11. Peel the protective backing fromthe hook and loop interlocking fastenersattached to the Six-Gun Diesel Tuner.Position the side edge of the Six-GunDiesel Tuner to the edge closest to theengine of the fuse cover, then pressthe adhesive onto the outside of thefuse box cover. Apply light pressure tothe Six-Gun Diesel Tuner by hand for60-seconds to create a strong bondbetween the fuse box and hook & loopinterlocking fasteners. Using the suppliedcable ties, secure the wire harnessaway from any heat sources or movingcomponents.CAUTION: When securing thewires, do not bend them anytighter than a 2.5” diameter bendas this can cause undue stress onthe wires and may cause failure.-END, SECTION 1-96819 v.3.0 9