Heat-Tracing Systems for Hazardous Division 1 Locations
Heat-Tracing Systems for Hazardous Division 1 Locations
Heat-Tracing Systems for Hazardous Division 1 Locations
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Center16. Remove large plug from sealing fitting. Pull heating cable back through component hardware,centering end of outer jacket in sealing fitting opening. Be sure no yellow/green tubing extendsinto seal fitting.17. Position grommet in cavity. Install screws in compression gland and tighten firmly. Be careful notto change position of heating cable in sealing fitting. Screw corrugated tubing onto end ofcompression gland. Install tubing clamp.33