SV-Series Operation Manual - BJM Pumps

More documents

Recommendations

Info

Single phase pumps always use a three-prong groundedreceptacle. It is recommended that a Ground Fault Interrupter (GFI) type receptacle (orequivalent) be used.STOPPINGTo stop the pump (manual and automatic mode), unplug it from the power source, turnoff the breaker, or turn the power source off (generator).Typical 3 phase manual control 110
TYPICAL AUTOMATIC DEWATERING INSTALLATIONNOTE: Maximum recommended starts should not exceed 10 times per hour.AUTOMATIC OPERATIONFloat switches (wired into the pump motor or piggy-back style) are available from thefactory as an option.Note: 208V, 230V, 460V & 575V pumps do not have a plug installed.Three phase pumps need a separate control box with float(s) for automaticoperation.11
Page 1: INSTALLATION, OPERATION & MAINTENAN
Page 4 and 5: INTRODUCTIONThis Installation, Oper
Page 6 and 7: INSPECTIONReview all safety informa
Page 8 and 9: Do not run the pump dry.Pump liquid
Page 12 and 13: STOPPINGTo stop the pump (manual an
Page 14 and 15: Typical 3 phase Auto Control 1Befor
Page 16 and 17: Pump should be inspected at regular
Page 18 and 19: EXPLODED VIEW OF SV75018
Page 20 and 21: EXPLODED VIEW OF SV1500C20
Page 22 and 23: EXPLODED VIEW OF SV08C22
Page 24 and 25: EXPLODED VIEW OF SV22C, SV37C24
Page 26 and 27: SV SERIES PARTS LISTPump Model SV25
Page 28 and 29: SINGLE PHASE WIRING DIAGRAM 115V &
Page 30 and 31: 230VMODELS SV08, SV08C, SV15C, SV22
Page 32 and 33: 575VMODELS SV08, SV08C, SV15C, SV22
Page 35 and 36: BJM PUMPS, LLC123 Spencer Plain Roa
Page 37 and 38: START-UP REPORT FORMAre guide rails
Page 39 and 40: NOTES:

SV-Series Operation Manual - BJM Pumps

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?