DigiStar DVB-S PCI Card Quick install manual - MyGica

More documents

Recommendations

Info

From this window, you can see what type of card is configured for ProgDVB to use: 3. Configuring DiSEqC and LNB settings: One of the most important things to define is the DiSEqC switch parameter, whether you connect 1 or more satellites to your DVB card. (More than one satellite feed requires a DiSEqC switch). For each LNB you must enter the proper settings of LOF1, SWITCH, and LOF2. If you have only one LNB/antenna to your DVB card, select NONE on the DiSEqC box. If you connected many satellites or LNBs to your DVB card, select 1.0 OR 2.0 in the DiSEqC switch boxes. 4
Click a green dot, then select ADD LNB or highlight an already configured LNB, and click PROPERTY on the right. In the LNB settings window, select the correct values. Most satellites use the settings as in the following picture: For other satellites, such as Nimiq and Echostar satellites, the values are: Type: Ku or circular LOF1: 11250 SWITCH : 12700 LOF2: 0 POWER option is when your card powers the LNB. Once done, you are ready to scan your selected satellites. 4. Scanning satellites: Satellites transmit via many transponders, or emitters. You can scan part of a satellite or all of it. 5
Page 1 and 2: DigiStar DVB-S PCI Card Quick insta
Page 3: Select which option you want to add
Page 7 and 8: Remember: you need to scan each tra
Page 9 and 10: There are 3 types of feeds: There a
Page 11 and 12: This is the setup screen to adjust
Page 13: Access to almost all Free-to-Air sa

DigiStar DVB-S PCI Card Quick install manual - MyGica

Create successful ePaper yourself

Delete template?

Save as template?