OBSAH

Inalfa Event Spoiler Series Installation and Service ManualC. Installation InstructionsC.11 Wrapping the HeadlinerTrim the factory hardboard headliner; allowing for substrate clearance.Measure enough material to cover the headliner board.Apply trim adhesive to the back side of the new headliner material Allow 5 - 10 minutes forboth glues surfaces to set-up. (Glued surfaces will feel tacky to the touch)Use Headliner Material that meets FMVSS 302 Specification (Flammability)Trim the excess material around the outer edge, visors, consoles and handles of theheadliner board.Install the headliner into the vehicle.Pull the switch harness through he switch opening and connect the switch.Insert the switch into the substrate.Install the visors and retaining clips; insuring that the headliner is properly positioned.C.12 Wrapping Opening.Pre glue the headliner material in the area to be wrapped.Cut relief cuts in all four corners.Caution: Do not over cut the material for it may show.Pull and tack the headliner material to the leading edge.11 Installation Instructions