OBSAH

Inalfa Event Spoiler Series Installation and Service ManualC. Installation InstructionsC.7 Mainframe / Clamp Frame Installation cont.Optional Method:Apply a 1/4" bead of non-corrosive silicone to the underside of the mainframe. Care shouldbe taken to insure a continuous bead.Position the mainframe into the roof opening from the outside of the vehicle.Clean off any excess silicone around the frame edge.C.7.2 Install the Mainframe to the Trim RingFrom inside the vehicle raise the clamping frame to the Mainframe. Attach the front of theclamping frame around the motor, then attach to the mainframe.Position the rear portion of the clamp frame to mounting frame and attach the retainingscrews.Insert shim at the rear of the opening, to insure proper spacing between the glass and themainframe, approximately 1/8" (3.30mm) thick.Caution: Over tightening the screws will cause the roof skin distortion and undertightening could cause improper compression.7 Installation Instructions