OBSAH

Inalfa EVENT Installation Manual and Service ManualG. Trouble Shooting GuideMechanical FailuresProblem Possible Cause SolutionPanel misaligned LH/RH Timing of drive cables incorrect Re-time drive cablesGlass panel stopping prematurely. Obstacle in mechanism or guide rail Remove obstacleCable ratchetingCheck the motor and cable tube atmotor bracket and motor insertAlign cable tube to motor bracket and reinstallmotor properly.Electrical FailuresProblem Possible Cause SolutionOperating of the sunroof is possible, noauto close, no one touchSCU makes clicking noise but panel willnot movePanel is sliding too slowly. With a 13.5vpower supply, the panel should not takemore than 7sec. To close from fullyopened position.SCU in degraded mode due tomalfunctionLow voltageWeak batteryMisaligned panel creating dragWeak motorDirty mechanismRefer to B.2. Re-initilization ProcedureCheck power supplyChange or replace motorClean and grease mechanism or replace.Rattling NoiseProblem Possible Cause SolutionHardshade Loose attachment screws Tighten all T-25 attachment screwsSunshade rattling Check for felt pads on sunshade Add felt pads to sunshadeRattle in motor area Loose screws on motor Tighten screws or replaceWind NoiseProblem Possible Cause SolutionExcessive wind noise when the panel is inthe closed positionPanel seal not tight to glass panelLocking slider broken, replace Locking SliderSeal deformed, replace sealWater LeaksProblem Possible Cause SolutionWater coming through panel openingarea or headliner wetPanel seal not tight to glass panelLocking slider broken, replace Locking SliderSeal deformed or damaged, replace seal28 Trouble Guide