deniway® plate chain conveyor - Denipro

Project engineering information
The deniway ® construction kit has been designed to
implement a complete conveyor with the standard parts.
The conveyors can be adjusted to handle many different
requirements.
A few basic principles
for concept development and assembly
– Straight lines should be divided up into as many threemetre
sections as possible.
– Divide curves up into as large segments as possible.
Largest segment = 90°.
– A straight channel, at least L ≥ 300 mm, should always
be placed between changes of direction or transitions from
side curves to positive or negative curves.
– Channel supports in straight sections every 2 to 2.5 m,
in side curves every 1.5 to 2 m (curve dimensions). The
supports should be distributed evenly throughout the
conveyor.
– When using our standard supports, the table height is
850 mm.
The supports can be adjusted in a ± 100 mm range.
– The conveyor should include sideways guiders in sections
that are over head height.
29
Project engineering information
Please note
In exceptional cases, some conveyors might require different
procedures and equipment that vary from those outlined
above. At the project planning and assembly stage of the
conveyors, the appropriate statutory regulations and health
and safety regulations must be abided by.