Diamond Tools and Machines - English

WIRE SAWING 145
Application recommendation
Choosing the correct diamond wire
Performance
Level
Type Bead Machine Concrete
aggregate material
Level
of reinforcement
Dry
cutting
Brazed
Electroplated
L M H Soft Medium Hard Very
hard
Low
Very
high
100 %
DWM-C
x
DWM-CF
x
DWB-C
x
DWM-S
x
DWH-S | S-ATEX
x
DWM-C
x
DWM-C
x
Machine
Material
Suitability
Power
Aggregates
Optimal
Low L ≤15 kW
Very hard
Flint
Good
Medium M 15–25 kW
Hard
Quartz
Acceptable
High H 25–50 kW
Medium
Granite
Not suitable
Soft
Limestone
Service
+ Can be supplied with locking
mechanism attached on request
+ Can be delivered in unbroken lengths
of up to 100 m
+ Technical support provided by
our trained staff
Information / Recommendations
+ Optimum application conditions / wire speed
Concrete soft aggregates with little reinforcement 21–25 m / s
Concrete hard aggregates with high reinforcement 16–21 m / s
Steel 100 % 10–18 m / s
+ Assemble the connectors according to the instructions
+ Use only original Tyrolit accessories
+ Caution: Do not use shears for cutting. Use an angle grinder
with a thin cut-off wheel
+ The safety and operating instructions sent with the machine
must be observed at all times when using diamond saw wires.
The safety manual will be sent to you on request