Diamond Tools and Machines - English

FLOOR SAW BLADES 167
Application recommendation
Choosing the correct floor saw blade
Performance
Level
Type Machine Material
FSA L L
FSM-A M / H M
FSH-A H / X H
FSC L L
FSL-C L / M L
FSM-C M / H M
FSH-C H / X H
FSH-CX H / X H
Shaft-drive Cured concrete Green concrete Asphalt
B / D EL / HYD Very hard Hard Medium Soft Very hard Hard Medium /
Soft
FSX-C3 H / X H / X
FSL-G3 L L
FSL-G4 M L / M
FSM-G3 M / H L / M
FSM-G4 M / H M / H
FSM-G5 H / X H / X
FSH-G3 H X
FSA+C L L
FSL-A L / M L
Hard Medium /
Soft
FSA L L
FSU L L
Machine
Material
Suitability
Power
Shaft-drive
Aggregates
Optimal
Low L ≤15 kW
EL
Electric
Very hard
Flint
Good
Medium M 15–25 kW
HYD
Hydraulic
Hard
Quartz
Acceptable
High H 25–50 kW
B* Petrol
Medium
Granite
Not suitable
Very high X >50 kW
D* Diesel
Soft
Limestone
* with V-belt drive
Service
+ Bores and drive holes for special
machines are available on request
+ Larger diameters are available on request
Information / Recommendations
+ Optimum application conditions / peripheral speed
Asphalt
55–60 m / s
Cured concrete soft aggregates with little reinforcement 40–50 m / s
Cured concrete hard aggregates 35–45 m / s
Green concrete
50–55 m / s
+ The safety and operating instructions sent with the machine must be
observed at all times when using floor saws. The safety manual will
be sent to you on request.