Blitz Magazine

More documents

Recommendations

Info

Design specifications InteRFACe 15.2 Appliances subject to spillage of liquid in normal use shall be constructed so that such spillage does not affect their electrical insulation. 20.2 Moving parts of appliances shall, as far as is compatible with the use and working of the appliance, be positioned or enclosed to provide adequate protection against personal injury in normal use. This requirement does not apply to parts of an appliance that necessarily have to be exposed to allow the appliance to perform its working function. 22.6 Appliances shall be constructed so that their electrical insulation cannot be affected by water that could condense on cold surfaces or by liquid that could leak from containers, hoses, couplings and similar parts of the appliance. 22.9 Appliances shall be constructed so that parts such as insulation, internal wiring, windings, commutators and slip rings are not exposed to oil, grease or similar substances, unless the substance has adequate insulating properties so that compliance with the standard is not impaired. 22.12 Handles, knobs, grips, levers and similar parts shall be fixed in a reliable manner so that they will not work loose in normal use if loosening could result in a hazard. If these parts are used to indicate the position of switches or similar components, it shall not be possible to fix them incorrectly if this could result in a hazard. SKUDesign 23
technical summary InteRFACe Blade Housing $0.219 per part ABS 43g Safety Mech Insert $0.031 per part ABS 0.20g Safety Mechanism Rod $0.034 per part PC 0.5g Motor Base plate $0.133 per part PA66 30% GF 12.25g Button Housing $0.032 per part PC 0.9g SKUDesign 24
Page 1 and 2: Design specification Dylan shepparD
Page 3 and 4: ContentS Introduction..............
Page 5 and 6: Throughout the redesign process, it
Page 7 and 8: cpr reDesign BLItZ2Go LIFt The Blit
Page 9 and 10: Kinetic Interface enhanced Mobility
Page 11 and 12: cpr USeR InteRFACe As well as impro
Page 13 and 14: 18 Shaft Housing Bearing 19 Blade H
Page 15 and 16: cpr MARKet DeVeLopMent The Blitz2Go
Page 17 and 18: part Design LID + BottLe A major el
Page 19 and 20: technical summary LID + BottLe Lid
Page 21 and 22: part Design BoDy The body subassemb
Page 23 and 24: technical summary BoDy Body Shell $
Page 25: part Design InteRFACe The interface

Blitz Magazine

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?