PLIN-Slave - User Manual - PEAK-System

PLIN-Slave – User Manual
1 Introduction
The PLIN-Slave is an evaluation board with an interface for a LIN 2.0
bus. The device also has comprehensive I/O functionality which is
accessible through control and display elements.
The PIN-Slave is used in development and education, for example,
for testing purpose or as a teaching aid for handling the LIN
protocol.
The device is immediately ready for operation, a change of
configuration or programming is neither necessary nor intended (no
support).
1.1 Properties at a Glance
Supply voltage: 7 - 18 V
Based on Melexis MLX80103
1 LIN bus (v2.0), 19200 bit/s
5 digital inputs (low-active), already occupied
3 analog inputs (up to 18 V), already occupied
4 digital outputs (low-active), 500 mA each
4 digital outputs (high-active), 500 mA each
Extended operating temperature range from -40 to 85 °C
(-40 to 185 °F)
4