6009757_C-Fork Positioner Service Manual - Cascade Corporation
6009757_C-Fork Positioner Service Manual - Cascade Corporation
6009757_C-Fork Positioner Service Manual - Cascade Corporation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
I NSTALLATION<br />
3<br />
Mount <strong>Fork</strong> <strong>Positioner</strong> on truck<br />
A Center truck behind Attachment.<br />
B Hang Attachment onto truck carriage, or raise<br />
carriage into upper hooks (see inset).<br />
C Engage upper mounting hooks or sideshifting<br />
full-length upper hook. IMPORTANT: If<br />
sideshifter equipped, assure upper bearings<br />
are installed properly and centering tab<br />
engages center notch on truck carriage bar.<br />
ITA Class II – 0.60–0.66 in. (15–17 mm)<br />
ITA Class III – 0.72–0.78 in. (18–20 mm)<br />
ITA Class IV – 0.72–0.78 in. (18–20 mm)<br />
ITA Class II – 0.32–0.36 in. (8–9 mm)<br />
ITA Class III – 0.39–0.43 in. (10–11 mm)<br />
ITA Class IV – 0.47–0.51 in. (12–13 mm)<br />
4 Install<br />
or engage lower hooks<br />
Tap tight into position.<br />
If sideshifter, back off<br />
1 notch and<br />
check clearance:<br />
3/32 in. (2.4 mm) min.<br />
3/16 in. (4.8 mm) max.<br />
BOLT-ON TYPE<br />
������<br />
Tighten Capscrews:<br />
Class II, III Mounting – 165 ft.-lbs. (225 Nm)<br />
Class IV Mounting – 190 ft.-lbs. (255 Nm)<br />
Center<br />
Notch<br />
Truck<br />
Carriage<br />
SS0140.ill<br />
Sideshifting full-length<br />
upper hook shown<br />
Lower<br />
Carriage<br />
Bar<br />
Slide hook up<br />
to engage<br />
bar, install<br />
pin in locked<br />
position.<br />
(upper hole.)<br />
<strong>6009757</strong> Rev. 0 5<br />
C<br />
SS0139.ill<br />
FP0213.ill<br />
Back (Driver's) View<br />
B<br />
QUICK-DISCONNECT TYPE<br />
(optional)<br />
cascade ®<br />
C-675514-1<br />
C<br />
Lower<br />
Carriage<br />
Bar<br />
SS0141.ill<br />
B<br />
FP0366.ill<br />
SD0023.ill<br />
Sideshifter Upper<br />
Bearings (if equipped)<br />
Inspect hooks for<br />
excessive clearance.<br />
(Reverse guides to<br />
reduce clearance –<br />
see Step 2.)<br />
3/16 in.<br />
(4.8 mm)<br />
max.