Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.2 Interfaces Command Reference
From within the context of a logical system (which you can select from the main router
context by using the set cli logical-systems logical-system-name command), the show
interfaces command output is limited to the resources assigned to the logical system:
• The physical interfaces are listed by name, but no statistics are displayed.
• Only the logical interfaces assigned to the logical system are listed, with statistics
displayed.
• None of the special, system-generated logical interfaces with logical unit number 32767
are listed.
At the main router level (to which you can return from the logical system context by using
the clear cli logical system command), the show interfaces command output displays
statistics for all interfaces configured on the router:
• Statistics are displayed for all physical interfaces.
• Statistics are displayed for all logical interfaces.
• Statistics are displayed for all system-generated logical interfaces with logical unit
number 32767.
Example: show interfaces terse
16
Consider a main router for which you have configured the physical interface at-0/0/0
with ATM-specific physical interface properties and configured the physical interface
with a logical interface at logical unit 0. You have also configured logical system ls1 and
assigned a logical system administrator for this logical system. The logical system
administrator has assigned the logical interface at-0/0/0.0 to logical system ls1. The
configuration is as follows:
logical-systems {
ls1 {
interfaces {
at-0/0/0 {
unit 0 {
encapsulation atm-ccc-cell-relay;
vpi 0;
}
}
}
protocols {
mpls {
label-switched-path base_config_r4r1_lsp {
to 10.255.65.65;
}
interface all;
}
connections {
remote-interface-switch base_config_vp_mode_connection {
interface at-0/0/0.0;
transmit-lsp base_config_r1r4_lsp;
receive-lsp base_config_r4r1_lsp;
}
Copyright © 2012, Juniper Networks, Inc.