KSL-244 | Installation Instructions for Lathe Shields

SECTION 2 —MOUNTING BRACKETS
Lathe Shield Installation Manual
Introduction
Mounting brackets are supplied separately for any of the shields found
on pages 5-7. These brackets mount to the headstock of the lathe.
Fasteners are not furnished. The transparent and small steel shields
are attached to a zinc-plated extension tube which fits into these
mounting brackets.
There are two principal types of mounting brackets available. Type A
(Figure 2.1) is used for mounting to the top or the side of the headstock.
Type B (Figure 2.2) is used for mounting to the face of the headstock.
For difficult mounting conditions, the Type A1 bracket (Figure 2.3) may
be used. This bracket incorporates a telescopic height adjustment and
can be swivelled up to an angle of 90° as required.
Figure 2.1
Type A Bracket
Part No. LXS-650
For mounting to the top or
side of the headstock.
Figure 2.2
Type B Bracket
Part No. LXS-652
for mounting to the face of the headstock.
2 27 ⁄32”
1 1 ⁄2”
2”
1
⁄2”
1 1 ⁄2”
2 Holes .28” Dia.
1”
Bore
1”
Bore
1”
1 1 ⁄2” Dia.
Figure 2.3
Type A1 Bracket
Part No. LXS-651
for extended mounting to the
top or side of the headstock.
1” Bore
1 5 ⁄16”
Extends From 3 1 ⁄2”
to 5”
Shown Extended
3”
2 Holes .32” Dia.
1 1 ⁄4”
90° Movement of Center Piece
if Required
2 21 ⁄64”
1 1 ⁄2”
2”
2 3 ⁄8”
2 Holes .32” Dia.
(Continued on next page.)
Rockford Systems, LLC
Call: 1-800-922-7533 3
3”