Design, specification and constrcution of multi-use ... - Sport England

in BS 7044 Part 4 Appendix C.
2 Deviations are considered to be localised undulations 1000mm or
less in length. Deviations over 1000mm shall be considered
multiple deviations
3 Where-ever possible a MUGA should be built with a fall across
the principal direction the direction of play
A3.2 Surfacing requirements
A3.2.1 Surfacing durability
The surfacing shall comply with the following durability requirements.
Property Test Test
Requirement
method condition
Surface BS 7044 As detailed In accordance with Table 3 of BS
durability
in BS 7044
Part 4
7044 Part 4 Class O
Surface BS 7044 As detailed In accordance with Table 4 of BS
Environmental
in BS 7044 7044 Part 4
Resistance
Part 4
Tensile
properties
IAAF N/A Tensile strength: 0.4 MPA
Elongation at break: 40%
A3.2.2 Installation
There shall be no ridges, changes in the playing surface texture or bay
joints that result in erratic ball behaviour. Bay joints shall, as far as
possible, accord with play lines and be longitudinal along the length of
the court(s) with no discernible cross-joints.
A3.2.3 Line Marking
Line markings shall be in accordance with the relevant sports governing
body rules. Unless stated in the rules all lines shall be 50mm wide and
applied using at least two coats of paint. When measured with a
calibrated steel tape all line markings shall be within 20mm of their true
position as specified in the appropriate rule. Markings shall not deviate
by more than 10mm from a line joining their ends, nor include any
sudden steps. Line edges shall be parallel and uniform.
44
For info or comments please email mugas@sportengland.org