FOXBOX Tx/Rx VGA, VGA/YUV, DVI, and - Extron Electronics
FOXBOX Tx/Rx VGA, VGA/YUV, DVI, and - Extron Electronics
FOXBOX Tx/Rx VGA, VGA/YUV, DVI, and - Extron Electronics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation <strong>and</strong><br />
Operation<br />
Installation Overview<br />
Mounting the Unit<br />
This sections details the installation of the <strong>FOXBOX</strong> <strong>Tx</strong>/<strong>Rx</strong>, including:<br />
• Installation Overview<br />
• Mounting the Unit<br />
• Connections <strong>and</strong> Configuration<br />
• Operation<br />
Follow these steps to install <strong>and</strong> set up an <strong>Extron</strong> <strong>FOXBOX</strong> transmitter <strong>and</strong> receiver system<br />
for operation:<br />
1. Turn off all of the equipment. Ensure that the video sources <strong>and</strong> the output display are<br />
all turned off <strong>and</strong> disconnected from the power source.<br />
2. Mount the transmitter <strong>and</strong> one or more receivers (see “Mounting the Unit”, below).<br />
3. Connect the cables <strong>and</strong> configure the receivers (see “Connections <strong>and</strong><br />
Configuration”).<br />
4. Plug in the power supplies, then turn on the display devices <strong>and</strong> the input devices.<br />
CAUTION: Installation <strong>and</strong> service must be performed by authorized personnel only.<br />
Detailed mounting instructions can be found in the “Reference Information“ section.<br />
Any of the 1-inch high, quarter-rack width units can be placed on a tabletop, mounted on a<br />
rack shelf, mounted under or through a desk or other furniture, or mounted to a projector<br />
bracket.<br />
<strong>FOXBOX</strong> <strong>Tx</strong>/<strong>Rx</strong> • Installation <strong>and</strong> Operation 7