FOXBOX Tx/Rx VGA, VGA/YUV, DVI, and - Extron Electronics
FOXBOX Tx/Rx VGA, VGA/YUV, DVI, and - Extron Electronics
FOXBOX Tx/Rx VGA, VGA/YUV, DVI, and - Extron Electronics
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
p Mode switch —<br />
DIP switch 1 — To connect the received optical input to another receiver in a daisy<br />
chain configuration, set DIP switch 1 to up as shown. Up to 10 properly-configured<br />
receivers can be connected in a daisy chain to a single transmitter.<br />
DIP Switch 2 — DIP switch 2 must be set to the up position for the receiver to respond<br />
properly to the Video Shutdown Delay SIS comm<strong>and</strong>.<br />
q Configuration port — Connect a controlling device, such as a PC, to this port via a<br />
2.5 mm mini jack TRS RS-232 cable for RS-232 protocol control of all <strong>FOXBOX</strong> functions.<br />
See “Front panel Configuration ports“ on page 16 for more details on the adapter<br />
cable <strong>and</strong> “Remote Control“ on page 19 for SIS comm<strong>and</strong>s <strong>and</strong> software control.<br />
The TRS RS-232 cable is included with the <strong>Tx</strong> models.<br />
r DC power connector — Plug the included external 12 VDC power supply into this<br />
connector (see “Power supply wiring“ on page 17 to wire the connector.<br />
s Indicators —<br />
Power LED — This LED lights to indicate that power is applied to the unit.<br />
Over Temp LED — This LED lights to indicate that the unit is operating at a dangerously<br />
high temperature (approximately 167 °F [75 °C]) <strong>and</strong> that equipment damage is<br />
imminent.<br />
RGB (<strong>FOXBOX</strong> <strong>VGA</strong>) or <strong>DVI</strong> (<strong>FOXBOX</strong> <strong>DVI</strong>) LED — This LED lights on the receiver<br />
when the transmitter detects a signal on its video input, as follows:<br />
RGB LED — Horizontal sync (H) (for RGBHV video) or Green (Sync on green) (G) (for<br />
RGsB or RsGsBs video)<br />
RGB/<strong>YUV</strong> LED — Horizontal sync (H) (for RGBHV video) or luminance (Y) (for<br />
component video)<br />
<strong>DVI</strong> LED — <strong>DVI</strong> video input<br />
Audio LED — This LED lights on the receiver when the transmitter detects a low level<br />
audio signal for a short period of time. It goes dark if the audio signal drops below the<br />
minimum threshold for a short period of time.<br />
MODE<br />
<strong>FOXBOX</strong> <strong>Tx</strong>/<strong>Rx</strong> • Installation <strong>and</strong> Operation 13<br />
1 2