SWX â€B†Series Operator's Manual - Shuttlewagon mobile railcar ...
SWX â€B†Series Operator's Manual - Shuttlewagon mobile railcar ...
SWX â€B†Series Operator's Manual - Shuttlewagon mobile railcar ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Lubrication and Servicing<br />
Cummins Fuel Filter and Fuel Water Separator (B <strong>Series</strong>)<br />
The following instructions are for Cummins B <strong>Series</strong> engines. Remember, do<br />
not over tighten filter and drain plugs. Refer to engine manual for more<br />
detailed specifications.<br />
To remove<br />
•<br />
water from fuel water separator:<br />
Open the drain valve (item 1) on the bottom of the fuel-water<br />
•<br />
separator (item 2) by turning the knob clockwise.<br />
When clean fuel is visible, close the valve (item 1) by turning the<br />
knob counterclockwise.<br />
To service<br />
•<br />
and replace filters:<br />
Unscrew the fuel-water separator (item 2) and fuel filter (item 3),<br />
•<br />
from the filter head (item 4).<br />
Clean the area around the filter head and clean the gasket<br />
•<br />
surfaces on the bottom of the filter head (item 4).<br />
Fill each of the new filters with clean fuel and lubricate the O-ring<br />
•<br />
seals (item 5) with clean lubricating oil.<br />
•Install the filters as specified by the filter manufacturer.<br />
•Remove worm clamps (item 6) on in-line filter (item 7).<br />
Remove old in-line filter, replace and reattach worm clamps.<br />
1. Drain Valve<br />
2. Fuel Water Separator<br />
3. Fuel Filter<br />
4. Filter Head<br />
5. O-ring Seal<br />
6. Worm Clamp<br />
7. In-line Fuel Filter<br />
5<br />
Illustration I-IV. B <strong>Series</strong> Cummins Fuel-Water Separator and Fuel Filter.<br />
1<br />
2<br />
4<br />
7<br />
6<br />
5<br />
3