Instruction Manual Hub Dynamo - dbap GmbH
Instruction Manual Hub Dynamo - dbap GmbH
Instruction Manual Hub Dynamo - dbap GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Important <strong>Instruction</strong>s<br />
Safety Tips<br />
The hub dynamo in the SR SUNTOUR DH-CT600 series is designed for use with bicycles<br />
intended for public road transport. SR SUNTOUR does not accept any liability for any accidents<br />
and damage whatsoever if caused by failure to comply with the intended use of this product.<br />
WARNING!<br />
The following points should be observed in the interests of safety:<br />
• <strong>Hub</strong> dynamos in the SR SUNTOUR DH-CT600 series are designed for use<br />
with city and trekking bicycles intended for public road transport on surfaced<br />
bicycle paths.<br />
• Do not make any technical alterations to the hub dynamo in the SR SUNTOUR<br />
DH-CT600 series that could impair the operational safety of the bicycle.<br />
• The hub dynamo in the SR SUNTOUR DH-CT600 series limits the total<br />
admissible weight of the bicycle to 120 kg. If the bicycle manufacturer states<br />
that the total admissible weight is lower or if another component on the bicycle<br />
reduces the total admissible weight, the lower admissible total weight is<br />
relevant.<br />
• Follow the instructions provided by the fork and bicycle manufacturers in<br />
addition to the instruction manual.<br />
Safety check to be performed when switching on the hub dynamo and<br />
before every journey<br />
Before every journey check:<br />
• the front wheel to ensure that the tightening torque of the hub axle nuts is correct.<br />
• the front wheel for excessive clearance in the hub mounting.<br />
• that the cabling is intact and positioned correctly and that the headlight and rear light are<br />
working.<br />
Fitting<br />
To fi t the hub dynamo from the SR SUNTOUR DH-CT600 series on the front wheel, follow the<br />
steps below:<br />
1. Remove the nuts (2 items FG9.5; #3) and washers (2 items DIN125A-M10; #2) on the left<br />
and right-hand sides of the front axle.<br />
Note: Depending on the type of fork, instead of the 2 washers (DIN125A-M10; #2)<br />
2 special collar disks must be used to ensure the system is fail-safe.<br />
2. Insert the front wheel in the fork of your bicycle so that both sides of the axle engage with the<br />
front ends of the fork. The front wheel must be adjusted so that the cable connection terminal<br />
(#5) is on the right-hand side of the bicycle.<br />
Ensure that the connection terminal is aligned parallel to the fork blades.<br />
<strong>Instruction</strong> <strong>Manual</strong> <strong>Hub</strong> <strong>Dynamo</strong> DH-CT600, Page 3
Change language