SINUMERIK 840D sl CNC Software with ShopMill 1.5 SP3 - Support ...
SINUMERIK 840D sl CNC Software with ShopMill 1.5 SP3 - Support ...
SINUMERIK 840D sl CNC Software with ShopMill 1.5 SP3 - Support ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SINUMERIK</strong> <strong>840D</strong> <strong>sl</strong> 2010-07-01<br />
<strong>CNC</strong> <strong>Software</strong> <strong>ShopMill</strong> <strong>1.5</strong> <strong>SP3</strong><br />
AP00950890: SM: Cycles Alarm 61099: Block %2: Internal cycle error (1) -> E_SP_RP <strong>with</strong> G18<br />
Expansion of the operator interface for manual machine.<br />
AP00939206: Contents of cmm_single.mpf are not deleted<br />
Restrictions which apply to <strong>ShopMill</strong>:<br />
o A successful machine test (segment-specific test according to acceptance protocol) is required for the<br />
release of the function “automatic measuring equipment for tool gauging”.<br />
The acceptance protocol is stored on the software DVD under:<br />
sw_<strong>1.5</strong>_HF5\documentation\acceptance_protocol<br />
o When 0 is entered for the setup feedrate in <strong>ShopMill</strong> under "Settings", the axes will traverse at the<br />
velocity specified in machine data 32020.<br />
o You can use only a TOA area.<br />
o AP00631062: OP switchover problem <strong>with</strong> installed add-on software, e.g. Tran<strong>sl</strong>ine.<br />
Remedy: The resolution can only be switched over <strong>with</strong> PCU50 if <strong>ShopMill</strong> or ShopTurn is entered as<br />
runup task in the Regie.ini.<br />
o AP00658965: Exception for the operator interface when using the interface signal DB19.dbx18.0 (tool<br />
data adjustment).<br />
Remedy: The interface signal need no longer be used when setting the <strong>ShopMill</strong>/ShopTurn standard<br />
data<br />
$MN_TOOL_DATA_CHANGE_COUNTER to 0xF (MD 17530) and<br />
$MC_TOOL_DATA_CHG_BUFF_SIZE to 80 (MD28450) at least.<br />
© Siemens AG 2010 I DT MC R&D 51 Page 44 of 44<br />
All rights reserved
Change language