Instruction Manual - Topcon SL-D2 - Cal Coast Ophthalmic ...

More documents

Recommendations

Info

2 Loosen the fixing screw on the outside of the fitting cavity of the illumination unit with a screwdriver. Align indices and slowly lower the illumination unit onto the shaft of the base unit. When fitting the illumination unit, take care not to get your finger caught in between the assemblies. 3 Firmly tighten the fixing screw with a screwdriver. 18 ASSEMBLY PROCEDURE Indices To allow smooth rotation of the illumination unit, do not fasten the screw too tight.
CONNECTING AND SETTLING CABLES 1 Connect the cable of the illumination unit and the power cable to the power supply. 2 Pass the 5 pin connector from the metal plug connected to the power supply through the hole of the chinrest and connect to the base unit. 3 Fit the cable cover with 2 screws (10). 4 Pull the base unit toward the side of the operator, then lock. Attach the cables to the back of the table with the cable clip. 5 Move the base unit and illumination unit, and make sure there is enough cable to allow free movement of the base unit in all directions. FITTING THE CHINREST TISSUE Illumination cable Fixation cable Power cable 1 Remove the chinrest tissue pins. 2 Take approximately 1/5th of the pad of chinrest tissues and secure at each end, with the pins. 19 ASSEMBLY PROCEDURE
Page 1: INSTRUCTION MANUAL SLIT LAMP SL-D2
Page 4 and 5: MAINTENANCE AND CHECKS 1. Regularly
Page 7 and 8: CAUTION Icons Prevention item This
Page 9: WARNING INDICATIONS AND POSITIONS T
Page 12 and 13: CONFIGURATION NAMES OF MAIN BODY CO
Page 14: Spare chinrest tissue pin (2) Clean
Page 17 and 18: SECURING THE UNIT TYPE TABLE TOP 1
Page 19: SECURING THE BINOCULAR TUBES 1 Alig
Page 23 and 24: SO-TM3 1 Align the locating pins of
Page 25 and 26: 2 Insert the auxiliary spring unit
Page 27 and 28: 9 While holding the prism box, look
Page 29 and 30: OPERATION PROCEDURES FIXING THE PAT
Page 31 and 32: 4 To fix the base, fasten the base
Page 33 and 34: SWINGING THE SLIT SIDEWAYS Turn the
Page 35 and 36: SPECIFICATIONS AND PERFORMANCE SPEC
Page 37 and 38: SYSTEM CONFIGURATION SL-D2/SL-D4/SL
Page 39 and 40: MAINTENANCE AND CHECKUPS PERIODIC M
Page 41 and 42: 4 Pull off the socket plug. 5 Pull
Page 44 and 45: CLEANING THE SLIDING PLATE, RAIL AN
Page 46 and 47: CONNECTABLE CAMERA Recommendation F
Page 48 and 49: TV ATTACHMENT TL-57 • Used to con
Page 50 and 51: PARALLEL BINOCULAR TUBE PB-2 FEATUR

Instruction Manual - Topcon SL-D2 - Cal Coast Ophthalmic ...

Create successful ePaper yourself

Delete template?

Save as template?