Operating Instructions TURBOMAT TM 150 / 220 - Econergy Ltd
Operating Instructions TURBOMAT TM 150 / 220 - Econergy Ltd
Operating Instructions TURBOMAT TM 150 / 220 - Econergy Ltd
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Switching on the System<br />
The main switch is located under the control unit.<br />
F R Ö L I N G<br />
. . . . . . . . .<br />
Switched off<br />
OFF ←<br />
!<br />
After switching on the control unit, the text FRÖLING appears.<br />
The control unit performs a system check.<br />
After the system check, the display is located in the display menu.<br />
You can read the actual (measured) values in this menu.<br />
DANGER: Never stop the boiler using the main switch!<br />
Stop the boiler using the red STOP key<br />
Important control steps<br />
Start system Press green button (I)<br />
or open the insulating<br />
door<br />
Shut down the<br />
system<br />
Modify parameters<br />
and values<br />
Press red button (0)<br />
1. Select menu<br />
2. Select<br />
parameters<br />
3. Press Enter-key<br />
4. Change the value<br />
5. Confirm with the<br />
"Enter" key<br />
Push-button Note<br />
O<br />
O<br />
Enter Back<br />
Enter<br />
Enter<br />
The main switch must be switched on<br />
CAUTION DANGER:<br />
Never stop the boiler using the main switch!<br />
You will find an overview of the menu structure<br />
in chapter Fehler! Verweisquelle konnte nicht<br />
gefunden werden.<br />
A question mark appears next to the parameter<br />
value. Now the value can be changed.<br />
The "up-arrow" key increases the value.<br />
The "down-arrow" key decreases the value.<br />
Value is saved.<br />
If the "Back" key is used instead of the "Enter"<br />
key, the change is not accepted<br />
18 B0310003 Edition 2003