Operating Instructions TURBOMAT TM 150 / 220 - Econergy Ltd

Set boiler
In the "SET" operator menu, parameters and values can be modified. In order to avoid unnecessarily operating the heating
system under a full load, the loading times can be set on a timer for hot water preparation:
for example, the boiler loading process should begin tomorrow before the start of the heating phase.
The parameters "BEGIN and END the loading process" only appear if no storage tank was configured (See system
schematics)
Boiler ... ← Desired boiler temperature 55°←
There is only a
display if there
is no store
Set heating
Reload if boiler under 45°←
When the set temperature is reached in the boiler, the boiler loading
pump disengages.
Reloading of the boiler is authorized when the boiler temperature is
below this temperature.
Start of the first loading session 03:00← Start of the authorization for the first boiler loading session
End of the first loading session 05:00← End of the authorization for the first boiler loading session
Start of the second loading session 14:00← Start of the authorization for the second boiler loading session
End of the second loading session 16:00← End of the authorization for the second boiler loading session
In the "SET" operator menu, the heating program's parameters and values can be modified.
It is possible to control two heating circuits
(NOTE: It is not possible in the standard delivery configuration, but it is optional to buy).
The heating phases represent the start and end of the increased heating demand in the course of one day.
Each day can be given individual heating times (seven different heating times with two heating phases each), or the same
heating times can be used on different days.
This setting is made in the weekly program submenu.
What's more, the room temperature desired value can be set to the heating or drawdown phase.
Heating circuit 1... ← Weekly program
M, Tu, W, Th, F, Sa, Su
1 1 3 1 1 2 5
Heating prog. Heating prog. 1
Heating prog. 2 - 7
Heating phase 1
Start 06.00
End 22:00
Heating phase 2
Start 24:00
End 24:00
Room temperature desired value 20°←
Room temp. desired value
in cool down mode 16°←
For heating circuit 1, heating time programs 1-7 are
assigned to the days of the week.
Room temperature desired value during the heating phase
� is only visible with the remote control.
Room temperature desired value during the drawdown
phase
� is only visible with the remote control.
Heating circuit 2... ← Programming as in heating circuit 1
Heating program 1
Heating program 2
Heating program 3
Heating program 4
Heating program 5
Heating program 6
Heating program 7
Start
1. heating phase
End
1. heating phase
Start
2. heating phase
End
2. heating phase
22 B0310003 Edition 2003